Estate Swing Manual de instrucciones descargar pdf (Pagina 20)

Installation of Operator—Push-to-Open

1. Find the proper set back for your operator (from

previous page). Do this by holding the bottom “L”

shaped bracket against the post. Marking its horizon-

tal positioning on the post using a vertical line up

from the middle of the bracket. Also mark your an-

gled bracket for positioning on the “L” shaped

bracket. The hole on the end of the angled bracket

should be in the setback position.

HINT: Trace the bracket on cardboard and use

the cardboard to make a template.

2.11

4. Insert a 3/8” x 1” bolt in

the center hole and a 5/16”

bolt in the rear hole. Secure

them using the provided

nuts and lock washers.

3. Position the angled

bracket between the two “L”

shaped brackets in the same

position as when the setback

was found. Clamp the 3

brackets together. Drill

through the angled bracket

using the pre-drilled holes in

the “L” shaped brackets us-

ing a 3/8” drill bit. Drill

through all three brackets

using a 5/16” drill bit in a

position behind the first

hole.

2. Cut off the excess length

(if any) of the angled

bracket using a hacksaw.

Before permanently attaching any brackets, be sure to test

arm motion and clearance.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Sin comentarios

Estate Swing Manual de instrucciones Pagina 20