Estate Swing Manual de instrucciones descargar pdf (Pagina 13)

Installation of Operator—Push-to-Open

E-S 500 / 502 Classic Series Instruction Manual

2.7

1. Find the proper set back for your operator (from

previous page). Do this by holding the bottom “L”

shaped bracket against the post. Marking its

horizontal positioning on the post using a vertical

line up from the middle of the bracket. Also mark

your angled bracket for positioning on the “L”

shaped bracket. The hole on the end of the

angled bracket should be in the setback position.

2. Cut off the excess length (if any) of the

angled bracket using a hacksaw.

3. Position the angled bracket between the

two “L” shaped brackets in the same position

as when the setback was found. Clamp the 3

brackets together. Drill through the angled

bracket using the pre-drilled holes in the “L”

shaped brackets using a 3/8” drill bit. Drill

through all three brackets using a 5/16” drill bit

in a position behind the first hole.

4. Insert a 3/8” x 1” bolt in the center hole

and a 5/16” bolt in the rear hole. Secure

them using the provided nuts and lock

washers.

HINT:

Trace the bracket on cardboard and

use the cardboard to make a template.

BEFORE PERMANENTLY ATTACHING ANY BRACKETS, BE

SURE TO TEST ARM MOTION AND CLEARANCE.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Sin comentarios

Estate Swing Manual de instrucciones Pagina 13