Estate Swing Manual de instrucciones descargar pdf (Pagina 46)

E-S 1000D Series Instruction Manual

Troubleshooting

5.1

If the gate opener will not move but the board is counting the run time:

• Check wiring connections.

• Check the 8 amp fuse near the bottom left side of the board - the proper way to inspect a

fuse is to remove it from its clips and check for continuity. The fuses have black covers on them

that need to be flipped open before the fuse itself is visible.

• Check the operator arms by hooking the red and black power wires directly to the battery.

The arm will move open or closed depending on which wire you put to positive or negative on

the battery, so have the gate halfway open before doing this test. Pulling the pin and screwing

the end of the arm out is the easiest way to put the gate in the halfway open position.

If the gate opener moves a few inches or feet and stops or reverses directions:

• Increase the force setting (P3).

• Check the setback. The setback of the operator is important to correct operation due to lev-

erage the arm will have on the gate.

• Check the battery voltage. Proper voltage should be between 12.5 - 13.8 and drop no more

than a quarter of a volt under load.

• Disconnect accessories that may be triggering the gate a second time. The most frequent

issues are from exit sensors or other automatic opening devices.

The gate does not reach the desired stop points:

• Adjust the limit switches. Move both limit switches in towards the center of the shaft and then

move them out after you are sure the limits are stopping the gate and not the arm just reach-

ing its physical limitation.

• Lengthen the run time parameter (P1). This parameter can only be too short so increase this

number to make sure that the limits are stopping the gate and not the run time.

• Check setback— if setback is incorrect it will limit how far the gate will move per inch of

stroke length.

If the gate will open but will not close:

• Cut power to the board by removing one of the wires going to the battery. Turn the auto

close dip switch to the off position. Manually move the gate slightly off the open position by

turning shaft and re-attaching to gate, plug the battery back in, then trigger the gate to go

closed. If the gate then moves closed the limits are most likely wired backwards. (Meaning

open limit is wired to closed and closed wired to open) Check the wiring. Make sure you are

following the Pull to Open instructions if the gate opens in towards the property and Push to

Open if the gate opens out towards the street.

• If you are not using safety devices the safety jumpers are in place. If PH is on display it is an

issue with the safety jumper or a device in the safety terminals.

Continues on next page.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 56 57

Sin comentarios

Estate Swing Manual de instrucciones Pagina 46